Page 1 of 1

Help with chamfering a square cutout detail

Posted: Wed Dec 19, 2018 10:28 pm
by ataylor99
Hi there, I have a simple detail that I'm having trouble with, probably because I am a bit new to the chamfer - turbosmooth workflow... I have a simple square cutout detail that I would like to apply this technique to. Attached are screenshots for the low poly:
The attachment chamfer_issue_01.PNG is no longer available
with chamfer applied:
The attachment chamfer_issue_02.PNG is no longer available
and with turbo smooth applied:
The attachment chamfer_issue_03.PNG is no longer available
You can see that with turbosmooth applied there is some unwanted pinching at the corners:
chamfer_issue_01.PNG
chamfer_issue_01.PNG (45.78 KiB) Viewed 608 times
What do I need to do to avoid this?

Re: Help with chamfering a square cutout detail

Posted: Wed Dec 19, 2018 10:31 pm
by ataylor99
Screenshots didn't work for some reason... here they are: